Fisher Price Baby Swing 75973 User Manual

Instructions  
Model Number 75973  
Lift & Lock Swing  
Please save these instructions for future reference.  
No assembly is required.  
For children 9 months - 3 years and up to 20 kg (45lbs).  
 
Placement and  
Play Area Surfacing  
Before installing the Lift & Lock Swing, select and  
prepare a play area.  
Placement  
Install the swing at least one meter (three feet) from any  
structure or obstruction such as a tree trunk, fence,  
garage, house, overhanging branches, laundry lines or  
electrical lines.  
Surfacing  
Following are guidelines from the U.S. Consumer  
Product Safety Commission’s Handbook for Public  
Playground Safety to minimize injuries that can result  
from falls. These guildelines apply to playground  
equipment including but not limited to swing sets and  
climbing equipment.  
Hard surfacing materials are not suitable for use  
under this equipment. Earth surfaces such as soils  
and hard packed dirt are also not recommended  
because their shock absorbing properties can vary  
depending on climatic conditions such as moisture and  
temperature. Grass and turf are not recommended  
because their effectiveness in absorbing shock during  
a fall can be reduced considerably due to wear and  
environmental conditions.  
Acceptable surfacing materials are available in two  
basic types: loose-fill and unitary.  
Loose-fill materials can have acceptable shock  
absorbing properties when installed at sufficient  
uncompressed depth of at least 15 cm (6 inches).  
These materials include sand (fine and coarse), gravel  
(fine and medium) and shredded wood products (wood  
mulch, shredded bark, wood chips). Loose-fills should  
not be installed over hard surfaces such as asphalt  
or concrete.  
The depth of any loose-fill material could be reduced  
during use resulting in different shock-absorbing  
characteristics. For this reason, a depth greater than  
the minimum recommended should be considered.  
Unitary materials are generally rubber mats or a  
combination of rubber-like materials held in place  
by a binder that may be poured in place at the  
playground site and cures to form a unitary shock  
absorbing surface.  
3
 
Installation of the  
Lift & Lock Swing  
The Lift & Lock Swing can be attached to a swing set,  
pole or tree branch.  
IMPORTANT! When installing the Lift & Lock Swing,  
be sure it cannot swing to within one meter (three feet)  
of any other object in front of, behind, or to the side of it.  
CAUTION  
Periodically inspect S-hooks for wear.  
Metal to metal contact between hooks  
may cause premature wear. If your swing  
set does not have a bushing, you may  
want to replace the existing hook with a  
hook and bushing assembly available at  
toy stores and home centers.  
Swing Set Installation  
Swing Set  
Hooks  
(not included)  
Bushing  
(not included)  
S-Hook  
(included)  
• Fasten the Lift & Lock Swing S-hooks (included) onto  
the hooks (not included) on your swing set.  
4
 
Installation of the  
Lift & Lock Swing  
Pole or Tree Branch Installation  
Pole  
Ropes  
S-Hook  
INPORTANT! Before installing, check the strength  
and stability of the pole or tree branch. Place the  
Lift & Lock Swing at least one meter (three feet)  
from a tree trunk or any other structure.  
• Wrap the S-hook end of the Lift & Lock Swing ropes  
around the pole or tree branch.  
• Hook the S-hook around the ropes. Pull down on  
the ropes to make sure the Lift & Lock Swing is  
securely fastened.  
5
 
Securing Your Child  
®
Restraint  
Bar  
Waist  
Belt  
®
Crotch  
Belt  
Release  
Lever  
• Pull the release lever toward you and raise the  
restraint bar.  
• Unbuckle the waist belts from the crotch belt.  
• Place your child in the swing.  
• Pull the crotch belt up between your child’s legs and  
fasten both waist belts to the crotch belt. Make sure  
you hear a “snap” on both ends.  
• Insert the restraint bar down into the latch until it snaps  
into place. Pull up on the restraint bar to be sure it is  
securely latched.  
B
Anchored End  
Anchored End  
Buckle  
A
A
B
Free End  
Free End  
To Tighten  
To Loosen  
To tighten the waist belts:  
• Feed the anchored end of the waist belt up through  
the buckle to form a loop A. Pull the free end of the  
B
waist belt  
.
• Repeat this procedure to tighten the other waist belt.  
To loosen the waist belts:  
• Feed the free end of the waist belt up through the  
A
buckle to form a loop . Enlarge the loop by pulling  
on the end of the loop toward the buckle.  
• Pull the anchored end of the waist belt to shorten the  
B
free end of the waist belt  
.
• Repeat this procedure to loosen the other waist belt.  
6
 
Removing Your Child  
®
Restraint  
Bar  
Release  
Lever  
• The release lever is located on the underside of the  
swing seat. Squeeze the release lever toward the  
front edge of the swing and lift the restraint bar. Slide  
the restraint bar up.  
• Squeeze tabs on the release buckles to unfasten the  
crotch belt from the waist belt.  
Helpful Hint: The restraint bar will remain in the up  
position for ease in placing a child in or out of the  
Lift & Lock Swing.  
Cleaning  
Wash the Lift & Lock Swing with a mild soap and water  
solution. Rinse with clean water to remove soap residue.  
Storage  
Remove the Lift & Lock Swing from your swing set or  
other location and store it indoors when the outdoor  
temperature drops below freezing.  
7
 
Three (3) Year Limited Warranty  
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag  
#870, Richmond, Victoria 3121 Australia, warrants to the  
original owner that the Lift & Lock Swing is free from all  
defects in material and workmanship when used under  
normal conditions for a period of three (3) years from the  
date or purchase. This warranty does not cover the swing  
ropes, color fading of the product or product parts, or  
damage from excessive weather abuse or acts of God.  
Should the product fail to perform properly, we will repair  
or replace it at our option, free of charge. Purchaser is  
responsible for shipping the product to Mattel Australia  
Pty. Ltd. at the address indicated above and for all  
associated freight and insurance cost. Mattel Australia  
Pty. Ltd. will bear the cost of shipping the repaired or  
replaced item to you. This warranty is void if the owner  
repairs or modifies the product. This warranty excludes  
any liability other than that expressly stated above  
including but not limited to any incidental or  
consequential damages.  
SOME STATES DO NOT ALLOW THE EXCLUSION OR  
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL  
DAMAGES, SO THE ABOVE LIMITATION MAY NOT  
APPLY TO YOU.  
THIS WARRANTY GIVES YOU SPECIFIC LEGAL  
RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS  
WHICH MAY VARY FROM STATE TO STATE.  
Consumer Information  
Australia: Mattel Australia Pty. Ltd., 658 Church Street,  
Locked Bag #870, Richmond, Victoria 3121 Australia.  
Consumer Advisory Service 1300 135 312.  
New Zealand: 16-18 William Pickering Drive, Albany 1331,  
Auckland.  
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.  
©2001Mattel,Inc. All Rights Reserved.® anddesignate U.S. trademarks of Mattel,Inc.  
Printed in Australia  
75973pr-0920  
8
 

Ecom Instruments Home Safety Product H 251 A User Manual
Edelbrock Automobile Parts 8822 User Manual
Eiki CRT Television LC XWP2000 User Manual
Eureka Vacuum Cleaner 100 110 User Manual
EverFocus Camcorder 520TVL 380TVL User Manual
Fluke Thermometer 07 402 User Manual
Fujitsu Mouse FKB 7681 Series User Manual
Gaggenau Microwave Oven EB 260 261 User Manual
Giant Water Pump GP7145GB User Manual
Globe Mixer SP8 User Manual